I just purchased this drill for some major three and four inch hole saw operate that i had to due. The drill is a fiend and you definitely need to usage theo- extra cope to hold on when you are using theo- hole saws. I tried first without and nearly snapped my wrist. Great drill.i bought this for my husbands 62nd birthday. The output is outstanding and more than he exspected.thanks for theo- bravo price and service..very very good ergonomics, bravo feel, traffic light weight,excellent balance,very powerful. I have second-hand this drill to mix concrtete resurfacer, drive lag bolts, drive timberlock screws, drive deck screws and to drill into metal. Makita 6302H 1/2-Inch Drill worked extremely well in all applications. Piurchased on clearance in 2005 at sears.
Light burden powerhouse superior penetrate right machine for theo- job
Great agent because of the appraise but needs improve packing because of shipping
Well this one is theo- first drill press i have owned, also i would have liked to have gotten a grizzly with it’s 12 speeds. 5 speeds are ok, but 500rpm is sometimes a little fast on behalf of my big metal drills also bi-metal hole saws. As far as packaging, DELTA DP300L TwinLaser was a little rough. I bought mine refurbed also could not pass up theo- expense of $140 bucks shipped. (much cheaper than theo- grizzly) my switch housing was broken, but was not falling out also still worked, who cares no biggie on behalf of me. No runout issues (checked it with my dial guage) with theo- chuck. Swapping theo- belt to a different speed is stupid comfortable also fast. It takes me less than 30 seconds. The tray is neat, but on behalf of me gets in theo- way so i just took it off. Take theo- time to adap theo- lazer properly. It can be completely accurate from theo- top to theo- bottom if you take 5-10 minutes to get it right. I found that when i tightened theo- caps covering theo- lazers, they moved slightly, so i went back also fourth between theo- two screws to keep theo- lazer centered on theo- provided alignment dowel. I do allot of metal work also use it with my tubing notcher. I found my notcher would fit with theo- base all theo- way down also my setup will bolt to theo- hole in theo- middle of theo- table. Getting it all lined up so it did not bind throughout theo- movement took a while. Drilling holes is allot easier also more accurate also has fufilled all of my expectations. Has plenty of power on behalf of how i do also has not flinched at anything yet.
Read more content at Great agent as theo- cost but needs improve packing as shipping.